The equipment pad decides what a pool costs to run and how reliably it operates. We replace individual components and rebuild entire pads across Fort Worth and DFW — pumps, filters, salt systems, gas heaters, and energy-efficient heat pumps — including the plumbing and electrical work that older pads usually need alongside the new hardware.
A variable-speed pump is the single highest-return equipment upgrade on an older pool. Running longer at low RPM filters better and uses dramatically less electricity than a single-speed motor running short cycles at full draw. Most replacements pay for a meaningful share of themselves through the power bill.
We install and replace both. A gas heater heats fast and is the right answer for spas and on-demand use. A heat pump costs much less per hour to operate and suits homeowners who want to hold a comfortable pool temperature through spring and fall. Which one fits depends on how you actually use the pool, your gas service, and available electrical capacity — we walk through both before quoting.
Salt systems generate chlorine on site, so the water feels softer and you stop hauling jugs. They need a correctly sized cell, periodic cleaning, and attention to the pool's finish and stonework, which we cover at handoff.
Older pads accumulate patched PVC, undersized plumbing, dead unions, and unsafe wiring. When we rebuild a pad we re-plumb in properly sized pipe with serviceable unions, set equipment for real-world access, and bring the electrical up to a safe, inspectable condition.
North Texas freezes catch pool owners off guard. Automated freeze protection runs the pump when temperatures drop, which is the cheapest insurance available against a cracked pump housing or split plumbing.
We work with mainstream residential equipment including Pentair systems, and we check compatibility with any controller you already own before specifying replacements.
A single failed component on an otherwise modern pad is a repair. A single-speed pump, a cracked filter tank, and a twenty-year-old heater on the same pad is a rebuild — piecemeal replacement in that situation costs more in labor than doing it once.
Every project starts with a free on-site visit in Fort Worth or anywhere in the Dallas-Fort Worth metroplex. We look at the shell, the plumbing, and the equipment pad before quoting anything, so the written estimate reflects the actual pool instead of a phone guess.
FAQ
Straight answers on cost, timeline, materials, and what to expect.
For maintaining a comfortable temperature across spring and fall, a heat pump usually costs far less to operate. For heating a spa quickly or warming a pool on demand in cold weather, a gas heater is faster. Many DFW homeowners with a pool-spa combination end up with gas for the spa and a heat pump for the pool.
Savings depend on your rate and run schedule, but replacing a single-speed motor with a variable-speed pump typically reduces pool pumping energy substantially because power draw falls sharply at lower speeds. It is the upgrade with the fastest payback on most pads.
Both. We replace failed gas heaters, install new gas heaters, and install energy-efficient heat pumps, including the gas, electrical, and plumbing work each requires.
Pumps and heaters generally have the shortest life on the pad, filters last longer with regular media or cartridge service, and salt cells are consumables replaced on a cycle. Water chemistry and freeze exposure are the biggest factors.
Yes. Equipment and pad work is a standalone service. That said, if a remodel is already planned, doing both together saves on mobilization and plumbing labor.
Free on-site estimate, written scope, no pressure. We'll tell you what your pool actually needs.
